DEH-41473
Exhaust Plenum 90 Degree Vertical Elbow
The exhaust plenum vertical elbow is an optional item that can be used to extend the exhaust plenum above the switchgear
further in the equipment room (Figure F.19). The exhaust plenum vertical elbow can be oriented in either an upward or
downward orientation.
Figure F.19 Exhaust plenum 90 degree vertical elbow details
NOTICE: Use of optional flange clips (Figure F.10) may be
used in lieu of the #12-24 x 7/8 inch hardware. Two flange
clips may be installed on each long exterior flange and one
flange clip may be installed on each short exterior flange.
Use of the optional flange clips will still require the
installation of the 3/8-16 x 1 inch carriage bolts at each
exterior flange corner.
©2016 General Electric. All rights reserved.
Courtesy of NationalSwitchgear.com
AKD-20 AR / Entellisys AR Low-voltage Switchgear
Appendix F. Exhaust Plenum System Details
86