Exhaust Plenum 90 Degree Horizontal Elbow - GE AKD-20 AR Installation And Maintenance Manual

AKD-20 AR / Entellisys AR Low-voltage Switchgear
Appendix F. Exhaust Plenum System Details

Exhaust Plenum 90 Degree Horizontal Elbow

The exhaust plenum horizontal elbow is an optional item that can be used to extend the exhaust plenum above the switchgear
further in the equipment room (Figure F.20). The exhaust plenum horizontal elbow can be oriented in either a left or right
orientation.
Figure F.20 Exhaust plenum 90 degree horizontal elbow details
NOTICE: Use of optional flange clips (Figure F.10) may be
used in lieu of the #12-24 x 7/8 inch hardware. Two flange
clips may be installed on each long exterior flange and one
flange clip may be installed on each short exterior flange.
Use of the optional flange clips will still require the
installation of the 3/8-16 x 1 inch carriage bolts at each
exterior flange corner.
87
Courtesy of NationalSwitchgear.com
©2016 General Electric. All rights reserved.
DEH-41473