Exhaust Plenum Transition Adapter - GE AKD-20 AR Installation And Maintenance Manual

Entellisys ar low-voltage switchgear
Table of Contents

Advertisement

AKD-20 AR / Entellisys AR Low-voltage Switchgear
Appendix F. Exhaust Plenum System Details

Exhaust Plenum Transition Adapter

The exhaust plenum transition adapter is attached to the left and right most plenum sections at the end of the equipment
assembly (Figure F.14).
Figure F.14 Exhaust plenum transition adapter details
NOTICE: Use of optional flange clips (Figure F.10) may be
used in lieu of the #12-24 x 7/8 inch hardware. Two flange
clips may be installed on each long exterior flange and one
flange clip may be installed on each short exterior flange.
Use of the optional flange clips will still require the
installation of the 3/8-16 x 1 inch carriage bolts at each
exterior flange corner.
81
Courtesy of NationalSwitchgear.com
©2016 General Electric. All rights reserved.
DEH-41473

Advertisement

Table of Contents
loading

Table of Contents