Connecting A Vcr - Samsung LNR1550 Manual

01 BN68-00816A-00.qxd
I
N S TA L L AT I O N

Connecting a VCR

These instructions assume that you have already connected your TV to an antenna or a
cable TV system (according to the instructions on pages 6-9).
Skip step 1 if you have not yet connected to an antenna or a cable system.
1
Unplug the cable or
antenna from the
back of the TV.
2
Connect the cable or
antenna to the ANT IN
terminal on the back of
the VCR.
3
Connect an RF cable
between the ANT OUT
terminal on the VCR
and the ANT IN
terminal on the TV.
An RF cable is usually included with a VCR. (If not, check your local electronics store).
4
Connect an audio cable
between the AUDIO OUT
jacks on the VCR and
the AV IN [L-AUDIO-R]
jacks on the TV.
If you have a "mono" (non-stereo) VCR, use the Y-connector (not supplied) to hook up to the left
and right audio input jacks of the TV.
2/1/05 4:14 PM Page 10
Incoming Cable
or Antenna
VCR Rear Panel
VCR Rear Panel
RF Cable <Optional>
VCR Rear Panel
Audio Cable <Optional>
6
English-
TV Rear Panel
TV Rear Panel