Page 1
O U R Rear Panel Jacks Use the rear panel jacks to connect an A/V component that will be connected continuously, such as a VCR or a DVD player. For more information on connecting equipment, see pages 6 ~ 12.
VHF and UHF Antennas” on page 7. Antennas with 300-ohm Flat Twin Leads If you are using an off-air antenna (such as a roof antenna or “rabbit ears”) that has 300-ohm twin flat leads, follow the directions below. Place the wires from the...
TV. Separate VHF and UHF Antennas If you have two separate antennas for your TV (one VHF and one UHF), you must combine the two antenna signals before connecting the antennas to the TV. This procedure requires an optional combiner-adaptor (available at most electronics shops).
Page 4
If your cable box descrambles only some channels (such as premium channels), follow the instructions below. You will need a two-way splitter, an RF (A/B) switch, and four lengths of RF cable. (These items are available at most electronics stores.)
Page 5
Set the A/B switch to the “B” position to view scrambled channels. (When you set the A/B switch to “B”, you will need to tune your TV to the cable box’s output channel, which is usually channel 3 or 4.)
VCR and the AV IN [L-AUDIO-R] jacks on the TV. If you have a “mono” (non-stereo) VCR, use the Y-connector (not supplied) to hook up to the left and right audio input jacks of the TV. Page 10...
VCR and your TV. An RF cable is usually included with a VCR. (If not, check your local electronics store). Connect an audio cable between the AUDIO OUT jacks on the VCR...
* Each external input source device has a different back panel configuration. Connecting a DVD Player The rear panel jacks on your TV make it easy to connect a DVD player to your TV. Connect an audio cable between the...
Note: The maximum tilt angle is 13 degrees in the backward direction. Please do not tilt the TV outside the specified range. Using excessive force to tilt the TV may cause permanent damage to the mechanical part of the stand. Page 57...
<1> Fold the stand pressing the button on the back of the stand. <2> Align the mounting interface pad with the holes in the stand bottom and secure it with the four screws that come with the arm-type base, wall mount hanger or other bases.
P P E N D I X Installing the Wall Mount Kit Note : This installation is to be used when attaching the wall mount to a concrete wall. When attaching to other building materials, please contact your nearest dealer.
Page 12
P P E N D I X Installing the Wall Mount Kit Adjust LCD TV to the hook on the bracket and move in the direction of the arrow(Left) so that LCD TV can be com- pletely fixed to the bracket.