Front Panel Leds; Initial Installation Provisioning Options; Table 2. Front Panel Leds; Table 3. Default Provisioning Options - ADTRAN Total Access 3000 Installation And Maintenance Practice

Remote Management Module Installation and Maintenance Practice

Front Panel LEDs

The RMM provides front panel LEDs to display status information.
status descriptions.
LED Indication Description
Off Lack of power or power failure
PWR
Green Power up and initialization OK
Flashing User menu interface is active
Yellow Module Out of Service – Unassigned (OOS-UAS), or
Out of Service – Maintenance (OOS-MA)
Red Hardware or firmware failure
Off Module OOS-UAS
LAN
Green Port operational without any alarms
Flashing Data traffic present
Red Alarm condition on port
Off Module OOS-UAS
WAN
Green Port operational without any alarms
Flashing Data traffic present
Yellow Port in test mode
Red Alarm condition on port

Initial Installation Provisioning Options

Upon initial installation of the RMM, the unit is provisioned according to factory default
settings, shown in Table
All provisioning is handled through the System Controller Unit (SCU) communication link.
The unit retains provisioning data in a nonvolatile memory device in case of a loss of power to
the module.
Provisioning Option
CSU Code Loop Detect
DS1 Timing Source
DS1 Network Source
DS1-X Line Build Out
DSX-1 Line Coding
External Alarms
Service State
6

Table 2. Front Panel LEDs

3.

Table 3. Default Provisioning Options

Settings (Default in BOLD)
Enabled; Disabled
Recovered; Local
MUX; DSX-1
0 – 133 ft; 133 – 266 ft; 266 – 399 ft; 399 – 533 ft; 533 – 655 ft
B8ZS; AMI
Alarm #1 – 6
In Service; Out of Service – Unassigned; Out of Service – Maintenance
Table 2 lists the LEDs and
61181019L1-5C