Required Tools; Installation Methods - Extreme Networks AP460C Hardware User's Manual

AP460C, AP460S6C, AP460S12C Hardware Guide
Mount the AP460C, AP460S6C, or AP460S12C horizontally or vertically on a pole using the built-in brackets on the hardware, or on a solid flat sur-
face using an accessory bracket (see
lowing sections describe the installation process.
Before you install the device, make sure that you have all the materials and tools necessary, and familiarize yourself with the safety and site haz-
ard warnings.
For best performance, deploy devices in relatively open areas at least 100' (30.5 m) apart from each other.

Required Tools

To install your device horizontally or vertically on a pole, you will need the following items:
Two hose clamps that accommodate the diameter of the pole to which you are mounting the device.
l
A slotted screwdriver to tighten the hose clamps.
l

Installation Methods

Install the Device on a Vertical or Horizontal Pole
Use the following steps to install the device on a vertical or horizontal pole.
1. Thread two hose straps of the correct diameter for the pole through the slots in on the back of the device and around the pole. Hose straps
should be 1/2" (12 or 13 mm) wide and made of stainless steel.
2. While holding the device against the pole, use a slotted screwdriver to tighten first the top and then the bottom hose strap screws to a min-
imum torque of at least 14 inch-pounds until the device is secure. Make sure that the LAN glands are facing down (earth) to eliminate the
chance of water entering the chassis. If you are installing the device to sit on top of a horizontal pole, make sure the top of the device faces
up (sky) with the LAN glands are protected by the top.
AP460C, AP460S6C, AP460S12C Hardware Guide
"Accessories "). These devices can be installed in even the most extreme outdoor environments. The fol-
3
3