TAKATA MIDI I-SIZE PLUS Instructions Manual page 24

NOTE!
The inner padding and shoulder straps of the TAKATA
MIDI I-SIZE (PLUS) should be adjusted to the size of
your child, so as to provide maximum comfort and
maximum protection in the case of an accident.
[MIDI_I-SIZE_PLUS_017 + MIDI_I-SIZE_
PLUS_018] These components can be set to fi ve
different positions, via a special adjustment mechanism.
NOTE!
If you need to adjust the inner padding and/or shoulder
straps, ensure that the TAKATA MIDI I-SIZE (PLUS)
has approximately the same orientation as it would
have when installed in the vehicle.
Step 1 – Unlock the adjustable inner padding
[MIDI_I-SIZE_PLUS_019] Open the compartment
for the manual on the backside of the TAKATA MIDI
I-SIZE (PLUS) child car seat.
[MIDI_I-SIZE_PLUS_020] Fully depress the slider to
adjust the inner padding on the back of the TAKATA
MIDI I-SIZE (PLUS) child car seat.
Step 2 – Adjust and fasten the inner padding
Keep the slider pressed down, and at the same time,
slide the inner padding up or down, to adjust this and
the shoulder straps to the size of your child. Then
release the slider again. The slider is locked in place
when the metal arm clicks into the slots on each side.
CAUTION!
Whenever you adjust the seat, check that the slider is
locked into position again. To do this, gently try to
move the slider up or down, without pushing it in.
Adjust seat reducer for babies
The seat reducer for babies can be individually
adjusted in stages to ensure your child is in exactly the
right position in the seat. It consists of two upholstered
pads (one of which is foldable), the body support
insert and the head support insert.
[MIDI_I-SIZE_PLUS_056 a] Both pads, the
body support insert and the head support insert
(in the lower attachment position on the body
support insert) will be required from birth up to
approx. 60 cm.
[MIDI_I-SIZE_PLUS_056 b] The lower pad can
removed from approx. 61 cm to approx. 75 cm
and the head support switched to the upper
attachment position on the body support insert.
WARNING!
[MIDI_I-SIZE_PLUS_048 a + b] Always ensure that
all the AIRPADS are fi tted correctly and attached.
Failure to observe this notice may seriously risk your
child's safety in the event of an accident.
It may be necessary to adjust the inner padding or the
seat reducer for babies further, according to your
child's size. For further information on this, please see
Section 5 – Securing your child (Step 1 – Adjusting
and fastening the inner padding and strap).
Loosening the straps and opening the buckle
Before placing your child in the TAKATA MIDI
I-SIZE (PLUS) child car seat or removing your child
from it, loosen the straps and open the buckle. The
TAKATA MIDI I-SIZE (PLUS) features a central
lever that is used to loosen the straps.
WARNING!
[Magnets] This product contains magnets to make it
easier to secure and unfasten the child. Wearers of
electrically active implants (for example, pacemakers)
should not be exposed to the magnetic fi eld around
these magnets as this could result in electromagnetic
inference. If you are unsure, please contact your
paediatrician or GP. Additional information is available
at www.takata-childseats.com under FAQ.
Step 1 – Unblock the straps
[MIDI_I-SIZE_PLUS_021] To loosen the straps, pull
the lever up and hold it in this position.
Step 2 – Loosen straps
At the same time, pull the shoulder straps gently
forward as far as possible.
Step 3 – Open the buckle
[MIDI_I-SIZE_PLUS_022 a] To open the buckle,
press the red button on it, and remove the tongues. The
buckle can be folded down and held in position by the
magnets making it easier to lift your child in and out
of the seat.
[MIDI_I-SIZE_PLUS_022 b] The two tongues are
held together magnetically and can be easily separated
by pulling them apart and attached on the outside of
the seat shell also using the magnets.
Adjusting the seat inclination
[MIDI_I-SIZE_PLUS_023 + MIDI_I-SIZE_PLUS_024]
The inclination of the forward facing TAKATA MIDI
de
en en
fr
it
es
pt
nl
21