Table of Contents
Advertisement
Note: As with any other radio-transmitting device, do not touch the antenna while
using your device as this can affect call quality and can cause the device to operate
at a higher power level than is necessary.
The device begins searching for a network signal.
3.
Once the device finds a signal, the time, date, and day appear in the bottom of the
4.
display.
You're now ready to place and receive calls.
5.
Note: If you are outside of your carrier's coverage area, the Roaming icon (
display. If you are outside of your carrier's coverage or roaming area, the No Service icon (
device's display. If you cannot place or receive calls, try later when service is available, or at another location.
Turn Your Device Off
Press and hold the
Note: If your device is on and you press
device from being turned off accidentally.
Remove the Battery
Important! You must unplug the Travel Adapter (if it is connected) before removing the battery from the device during
charging to avoid damage.
Press and hold the
1.
Push in the battery lock inward (1) and hold it in that
2.
position.
Lift the battery away (2), as shown.
3.
Install a Memory Card
Open the memory card slot cover on the left side of your device.
1.
Slide a memory card (1) into the memory card slot,
2.
with the label side facing up.
Note: Your device is preset to use FAT16-formatted memory cards. If you insert a
FAT32-formatted memory card, the device will ask you to reformat the memory
card. If you do not, you will not be able to access the memory card from the
device. If you do format the memory card, you loose all data you've stored on it.
Press the memory card into the slot (2) until the card
3.
locks into place.
key for two or more seconds. Your device powers off.
for less than one second, the device will not power off. This prevents your
key to turn off the device (if on).
Activating Your Device
) appears at the top of the device's
) appears at the top of the
Section 1: Getting Started
9
Advertisement
Table of Contents
