Page 1
I N S T R U C T I O N S H E E T Flip-Flop Blocks 2142, 2143, 2144, 2145, 2678, 2679, 2688, 2689 Strictly follow all instructions to avoid an accident, damage to your vessel, personal injury or death. See www.harken.com/ manuals for additional safety information.
Page 2
Adjusting Cam Angle 1. Loosen cam arm locking plate screw and pull outward to disengage. 2. Rotate cam arm to desired position. 3. Press locking plate in and tighten screw. Avoid binding sheave, do not overtighten screw.
Page 3
Reversing Cam Cleat 1. Remove screws from cam. 2. Assemble as shown. Note: use plastic plate on cam bottom. 3. Tighten screws. Do not Part No. 57/75mm overtighten screws. H-26790B Cam pawls should snap shut smartly.
Page 4
IMPORTANT! Exposure to some teak cleaners and other caustic solutions can result in discoloration of part and is not covered under the Harken warranty. Warranty For additional safety, maintenance and warranty information see www.harken.com/manuals or...