Advertisement
Quick Links
I N S T R U C T I O N S H E E T
2142, 2143, 2144, 2145, 2678, 2679, 2688, 2689
Strictly follow all instructions to avoid an
accident, damage to your vessel, personal
injury or death. See www.harken.com/
manuals for additional safety information.
Mount using ends to mark drill
holes. Make sure they are square
and against sheave assembly.
Use all four (4) fasteners with backing plates, washers
and locknuts. Deck or mounting surface must solid,
designed for block load. Consult with builder.
Mount with 4 (SH) Sockethead Cap or (PH) Panhead Screws
2142, 2143, 2144, 2145
2678, 2679, 2688, 2689
Flip-Flop Blocks
Reeve
#10 (5 mm)
1 /4" (6 mm)
Line
Advertisement
Related Manuals for Harken 2142
Summary of Contents for Harken 2142
- Page 1 I N S T R U C T I O N S H E E T Flip-Flop Blocks 2142, 2143, 2144, 2145, 2678, 2679, 2688, 2689 Strictly follow all instructions to avoid an accident, damage to your vessel, personal injury or death. See www.harken.com/ manuals for additional safety information.
- Page 2 Adjusting Cam Angle 1. Loosen cam arm locking plate screw and pull outward to disengage. 2. Rotate cam arm to desired position. 3. Press locking plate in and tighten screw. Avoid binding sheave, do not overtighten screw.
- Page 3 Reversing Cam Cleat 1. Remove screws from cam. 2. Assemble as shown. Note: use plastic plate on cam bottom. 3. Tighten screws. Do not Part No. 57/75mm overtighten screws. H-26790B Cam pawls should snap shut smartly.
- Page 4 IMPORTANT! Exposure to some teak cleaners and other caustic solutions can result in discoloration of part and is not covered under the Harken warranty. Warranty For additional safety, maintenance and warranty information see www.harken.com/manuals or...