Makita Makstar BTD200 Technical Information page 3

R
epair
(2)Adjust the opening for steel ball inserting, to the cam groove top of spindle
as illustrated in Fig. 5.
(3)Take off 2 steel balls 5.6 with magnetic bar or tweezers from spindle.
(4)Loosen the handle of 1R045 turning it anti-clockwise
and remove hammer from spindle.
< Note > Set the hammer as illustrated in Fig.5A,
when removing it from spindle.
Otherwise steel balls 4
will fall off hammer.
(5)When assembling, adjust the "opening for steel ball inserting", to the "cam groove top" of spindle
and insert steel ball 4 into hammer as illustrated in Fig. 5.
(6) Apply MAKITA grease N No.2 in small volume to the position marked with black triangle mark.
See Fig. 6.
(3) Steel ball 5.6 x 2
(2) Steel ball 4 x 25pcs.
Cam groove top
of spindle
Steel ball 5.6 x 2pcs.
Opening for steel
ball inserting
Steel ball 4 x 25pcs.
1R165 Ring spring
setting tool B
Fig. 5A
Fig. 6
(1) Spindle
Hammer
Bottom view of spindle
(4) Spur gear 24
Apply MAKITA grease N No.2 in small volume
into the hole of spindle.
P 3 / 4
Spindle
Hammer
Ball bearing
6002LLB
Fig. 5