Advertisement
Safety Instructions (continued)
15.
If an extension cord is being used, the marked electrical
rating should be at least as high as the electrical rating of the
appliance. Cords rated for less amperage may overheat.
16.
Care should be taken when using the extension cord so that
it cannot be pulled or tripped over.
Problem
No light on
the switch.
The steamer heats
up but there is
no steam.
The steamer
ow light is
ashing.
Troubleshooting
Possible Cause
The steamer is not plugged in.
The household circuit breaker
has been tripped; there is a
blown fuse in the electrical
circuit.
The water reservoir is empty.
There is a mineral build-up in
the steamer.
There is a mineral build-up in
the steamer.
Solution
Plug the steamer power cord into
an electrical outlet.
Reset the household circuit breaker
or replace the blown fuse. Contact
an electrician or your area's electrical
provider.
Re ll the water reservoir.
Remove the mineral build-up.
It is normal for the ow of the steam
to stop for a few seconds. If it stays
o for longer periods, check for
mineral build-up.
06
Advertisement
