Hood Weights; Finstallation And Assembly; Place Of Installation; Unpacking And Transport - Electrolux HOST11 Installation Manual

Hood weights

E.4
MODELS
922728 HOST11
922723 HOCT11E
922732 HOSS11
922727 HOCS11E
922725 HOCV11E
922730 HOSV11
922729 HOST21
922724 HOCT21E
922731 HOSS21
922726 HOCS21E
F INSTALLATION AND ASSEMBLY
F.1 Place of installation
• The appliance must be installed in compliance
with the applicable local and national
regulations:
- concerning air intake and exhaust;
- the ventilation requirements specified for
cooking equipment must be met;
- special precautions must be taken when
there are other naked-flame appliances in
the same room, to prevent the return of
fumes;
- if the hood is installed over a gas appliance,
a non-self-resetting device that shuts off the
gas supply to the appliance if the hood
stops working must be fitted in accordance
with the national gas regulations;
- hood installation must comply with the
applicable gas regulations.
• The following items must be connected to an
extraction system by means of the hood
exhaust hole. The system must only be
installed by authorised persons in accordance
with:
- the required Aeraulic Performance (see
chap. E.2 – page 15);
the following manufacturer's installation
-
instructions;
- the local rules and regulations regarding
extraction systems, municipal building,
electrical systems, water drainage, health
authorisations, and any other applicable
regulations on air intake and exhaust
systems.
Kg lb
68 150
77 170
69 152
78 172
78 172
52 115
76 168
84 185
77 170
86 190
922728
922729
922730
922732
922731
• Before installing the hood, make sure the oven
is installed in compliance with the Oven
Installation Manual (chap. F - "INSTALLATION
AND ASSEMBLY")
• for AUSTRALIA only:
This appliance can only be installed by
authorised persons and in accordance with the
manufacturer's installation instructions, local
gas fitting regulations, municipal building
codes, electrical wiring regulations, local water
supply regulations, AS5601-gas installation,
health authorities and any other applicable
regulations. The appliance must be installed in
accordance with AS / NZS 3500.1 and AS/NZS
3500.3 standards. This unit is supplied with a
Watermark certified backflow prevention
device.
F.2 Unpacking and transport
1. Cut the plastic straps fixing the appliance to
the pallet;
HOST11
HOST21
HOSV11
HOSS11
HOSS21
17