Gcommissioning And Settings; Introduction; Oven Settings - Electrolux HOST11 Installation Manual

G COMMISSIONING AND SETTINGS

Introduction

G.1
CAUTION
Make sure the appliance is
connected to a water
drainage system, a power
socket, and to the oven
via the oven/hood
Interface cable.
Switch the oven on as indicated in the Installation
Manual (chap. G "COMMISSIONING AND
SETTINGS").
CAUTION
During operation, pay
attention to the hot areas
of the outer surface. Do
not place objects on the
outlets located at the
upper rear of the
appliance.
G.2 Oven settings
When the hood is switched on for the first time,
execute
following procedure on Oven:
- AL01 IM_HO_L1_L2_L3_L4
with TOUCH Oven (see annex document) or
- AL02 IM_HO_L1_L2_L3_L4
with DIGIT Oven (see annex document).
These procedures must be completed in order to
ensure correct operation of the hood and to allow
its use.
The checking procedure consists of 2 main steps:
1. Only for Level 4 Hood, check that the hood
symbol is present on the oven interface (Touch
Screen Panel); or
2. test hood operation by switching the oven on
and start a test program. Simulate oven door
opening and closing: the fan should change
speed.
23