Installing The Cooker Hood; Installation Requirements - Electrolux MCH 662 Instruction Book

Please ensure that when the appliance is installed
it is easily accessible to an engineer in the event of
a breakdown.
All installations must comply with the local
authorities requirements for the discharge of
exhaust air.
Incorrect installation may affect the safety of
this cooker hood.

Installation Requirements

Before installation check the wall to which the
cooker hood is to be fitted for electric cables,
water pipes or gas.
If it is necessary to fix the hood to a hollow
construction plaster or partition board structure then it
should be sufficiently reinforced to be quite rigid in the
area of the cooker hood mounting brackets, and the
appropriate rawl plugs used for this type of fixing (not
supplied).
Ducting
The ducting must be fire retardant 100mm (4"ins) in
diameter and the length should be no more than:
3 metres with one 90° bend
2 metres with two 90° bends
Bends of more than 90° will reduce the efficiency of the
hood and reduce the airflow.
Clearance Height
The cooker hood is designed to be fitted over a
cooking appliance at the clearance heights stated,
providing the maximum output of the appliance
beneath does not exceed the maximums quoted in the
Technical Specifications.
If the output of the appliance below the cooker hood
exceeds the maximum outputs quoted, please refer to
the cooker manufacturer's installation instructions.

INSTALLING THE COOKER HOOD

1 1