Table of Contents
Advertisement
To display the boiler temperature during heating of the
tank, open the door and press the button "J"
(Figure 17).
1
C2
WASH CYCLES
The wash cycle includes one wash with hot water and
detergent (min 55 °C or min 150 °F for Marine USPH
versions) and one rinse with hot water and rinse-aid
(min 82 °C or min 180 °F for Marine USPH versions).
Table of times
Standard cycle time with supply water at 50 °C.
ZUCI / AUCI / EUCI
EUCIM / EUCAIUSPH
EUCAIWL
EUCAIML
EUCAIMLG
A device lengthens the cycle time if the water in the
boiler has not reached the minimum temperature for
correct rinsing.
The cycle times and the temperature may be persona-
lised (e.g. increase of the rinse time and temperature).
The cycle times should only be set by a specialised
technician.
C3
OPERATION
The filling and heating stage has finished when the
display shows the tank temperature:
55°C
The appliance is then ready for use:
•
Open the door.
•
Pour the required amount of detergent into the tank
(in models without automatic dispenser).
•
Insert the rack containing the dirty dishes.
•
Close the door and select the suitable wash cycle;
the corresponding indicator light comes on and the
wash cycle starts.
Only for models with door lock device
•
A closing device locks the door for the entire dura-
tion of the wash cycle. By pressing the button of the
selected cycle, the cycle is stopped and the door is
released.
•
If the dishwasher is equipped with detergent and
rinse aid level sensors the message
1
2
3
90"
120"
240"
120"
180"
300"
90"
113"
173"
300"
420"
600"
360"
540"
660"
dEt 0
. may
appear on the display. This indicates no detergent
in the external tank.
After 5 cycles performed with a lack of detergent,
the dishwasher inhibits the start of other wash
cycles. Therefore the detergent level in the tank
must be restored (see par. "Manual activation").
•
The lack of rinse aid is signalled by the message
rAi 0
; this message is a warning that does not
stop performance of the wash cycles.
Wash cycles:
- Cycle I
For lightly soiled dishes: press button "J" (Figure 17)
(see table of times).
- Cycle II (recommended)
For normally dirty dishes: press button "H" (Figure 17)
(see table of times).
1
- Cycle III
For very dirty dishes: press button "F" (Figure 17) (see
table of times).
1
Only for models with incorporated water softener
If the salt container is empty, the messages
SAL END
or
are displayed at the start or end of the
cycle. Place the salt in the special container, following
the instructions given in the section "Undercounter
dishwasher with incorporated continuous water softe-
ner".
•
To stop the wash cycle, just press the selected
cycle button or open the door.
•
To continue the wash cycle, just press the selected
cycle button or close the door. The cycle starts
again from where it stopped.
Only for models with door lock device
At the end of the rinse stage the dishwasher carries
out a pause stage of 1 minute 45 seconds, during
which the time remaining for completion of the cycle is
displayed.
This procedure complies with the parameters required by
HTM (Health Technical Memorandum) 2030 guidelines.
In this case door lock hinders door opening, so
washing cycle cannot be interrupted.
1
2
2
3
2
3
SAL 0
13
Hide quick links:
Advertisement
Table of Contents
