Table of Contents
Advertisement
55°C
To display the boiler temperature during heating of the
tank, open the door and press the button "F"
(Figure 19).
1
C2
WASH CYCLES
The wash cycle includes one wash with hot water and
detergent (min 55 °C) and one rinse with hot water and
rinse-aid (min 82 °C).
Table of times
Standard cycle time with supply water at 50 °C.
NUC/ KUC/ EUC/ FUCA3DD
NUCA1DDG/ NUC1GMS
ZUCA
A device lengthens the cycle time if the water in the
boiler has not reached the minimum temperature for
correct rinsing.
The cycle times and the temperature may be persona-
lised (e.g. increase of the rinse time and temperature).
The cycle times should only be set by a specialised
technician.
C3
OPERATION
The wash cycle includes one wash with hot water and
detergent and one rinse with hot water and rinse-aid:
55°C
The appliance is then ready for use:
•
Open the door.
•
Pour the required amount of detergent into the tank.
•
Insert the rack containing the dirty dishes.
•
Close the door and select the suitable wash cycle;
the corresponding indicator light comes on and the
wash cycle starts.
Wash cycles:
- Cycle I
For not very dirty dishes or glasses: press button "F"
(Figure 19), (see table of times).
- Cycle II (recommended)
For very dirty dishes: press button "G" (Figure 19),
(see table of times).
1
2
3
120"
180"
-
90"
180"
-
90"
120"
240"
1
2
1
2
- Cycle III
For very dirty dishes: press button "H" (Figure 19) (see
table of times).
1
•
To stop the wash cycle, just press the cycle button
or open the door.
•
To continue the wash cycle, press the cycle button
again or close the door. The cycle starts from
where it was interrupted.
•
At the end of the wash, the dishwasher emits a
series of beeps and "END" blinks on the display:
END
Open the door and remove the rack containing the
clean dishes.
CAUTION
The appliance will not remove burnt food deposits
from dishes. Dishes with burnt-on food deposits
should be cleaned mechanically/chemically (for
example, pre-wash under running water) before
putting them in the dishwasher.
CAUTION
The use of "foaming"/non-specific detergents or in
any case detergents used in different ways from
that prescribed by the manufacturer, can cause
damage to the dishwasher and compromise
washing results.
CAUTION
Failure to remove the residuals of detergent possi-
bly used for manual prewash can cause malfunc-
tioning of the dishwasher and compromise
washing results.
Change the water in the tank two times a day.
The number of wash cycles control is enabled in
EUC3DPCAG versions. When the machine reaches
the set number of cycles, the display shows the mes-
sage
and
the wash cycle respectively. A tank water drain cycle
(see par. C4 END OF WORK AND DAILY CLEANING)
must now be done to ensure wash cycles with suffi-
ciently clean water. Attention: If the tank water drain
cycle is not done, the machine does not shut down but
will continue to carry out wash cycles, showing the
messages
and
1
2
3
2
3
, at the start and end of
.
13
Hide quick links:
Advertisement
Table of Contents
