Care And Maintenance; Cleaning The Press Tools - Viega Pressgun 6 Instructions For Use Manual

Press machine with battery
Hide thumbs Also See for Pressgun 6:
Table of Contents

Advertisement

Fault
After pressing, the press jaw
cannot be opened.
The press connector is incorrectly
pressed.
Oil escapes from the press
machine.
The motor runs, but the press
machine does not complete the
pressing.
* Remove the incorrectly or incompletely pressed press connector from the installation.
** Send the press machine to your nearest service partner for inspection and maintenance.
3.6

Care and maintenance

3.6.1

Cleaning the press tools

Press machine
Pressgun 6 press machine with battery
Cause
The pressing was unable to be
completed.
The press jaw dimension does not
match the press connector.
The press jaw was not positioned
square to the pipe axis on the
press connector.
The press contour is incorrect.
The press machine has a fault.
A seal in the casing is faulty or
there is a mechanical problem.
The oil level is too low.
The tools are subject to normal wear and tear; for this reason, they must
be maintained in regular intervals. The maintenance and servicing of the
tools must be carried out by service partners authorised by Viega.
NOTICE!
Damage due to fluids!
Make sure that no fluids get inside the press machine.
Never dip the press machine into fluids.
Requirements:
Solution
Press the Reset button and
remove the press jaw from the
press connector.
Check the press jaw and have
repaired as required.
Repeat the pressing*.
Use a press jaw that matches the
press connection dimension.
Make sure that the press jaw is
positioned square to the pipe axis
on the press connector.
Repeat the pressing*.
Check the press jaw and have
repaired as required.
Repeat the pressing* with an
operational press jaw.
**
**
Handling
23

Advertisement

Table of Contents
loading

Table of Contents