Unpacking And Inspection - Community VERIS 2 Operation Manual

Versatile installation systems
Table of Contents

Advertisement

UNPACKING AND INSPECTION

VERIS 2 loudspeakers are inherently rugged and are carefully packed in sturdy cartons. However, it is
wise to thoroughly inspect each unit after it has been removed from the packaging, as damage could
occur during shipping.
Please note that once the shipment has left your dealer or the Community factory, the responsibility
for damage is always borne by the freight company. If damage has occurred during shipping, you
must file a claim directly with the freight company. It is very important to contact the freight company
as soon as possible after receiving your shipment, as most freight companies have a short time limit
within which they will investigate damage claims. Make sure to save the carton and the packing
material, as most claims will be denied if these materials are not retained. Your Community dealer and
the factory will try to help in any way they can, but it is the responsibility of the party receiving the
shipment to file the damage claim.
It is always a good idea to retain the carton and packing materials indefinitely, if possible, in the event
that the unit may need to be returned to your dealer or distributor for repair in the future.
Each shipping carton contains the following items:
Loudspeaker System (Qty 1)
Operation Manual (Qty 1)
Warranty Card (Qty 1)
VERIS 2 models V2-6, V2-8, V2-26, and V2-28 include a
yoke-style mounting bracket at no additional charge.
DANGER: VERIS 2 rigging fittings are rated at a Working Load Limit (WLL) of 100 lbs
(45.4kg) with a 10:1 safety margin. No single rigging fitting should ever be subjected
to a load that is greater than this stated limit. Failure to heed this warning could result
in injury or death!
IMPORTANT: The flat-head Allen-drive rigging screws that come installed in each
enclosure must either be replaced with rigging brackets and threaded fasteners, or
they must be kept in place to seal the enclosure from air leaks. If the rigging fittings
do not remain sealed, air leaks will occur in the enclosure that will compromise the
low-frequency performance with distortion, reduced output, and premature driver
failure.
VERIS 2 – Operation Manual - Page 8

Advertisement

Table of Contents
loading

Table of Contents