Veris 2 Mounting Brackets And Accessories - Community VERIS 2 Operation Manual

VERIS 2 MOUNTING BRACKETS AND ACCESSORIES

Below are descriptions of mounting brackets, suspension kits and other accessories
manufactured by Community for use with VERIS 2 loudspeakers. In this section the terms
"suspension" and "fly" mean the same thing: to elevate the loudspeaker enclosure above
the ground surface. Consult the user's guide included with each part for detailed safety
instructions. It is the responsibility of the installer to insure that safe installation practices
are followed. Installation of loudspeakers should only be performed by trained and qualified
personnel. It is strongly recommended that a licensed and certified professional structural
engineer approve the mounting design.
IMPORTANT: All rigging fittings must remain sealed with the original fasteners, or with
added rigging fasteners. Otherwise air leaks will occur in the enclosure that can
compromise the low-frequency performance with distortion, reduced output, and possible
driver damage.
WARNING: VERIS 2 rigging fittings are rated at a Working Load Limit of 100 lbs (45.4kg)
with a 10:1 safety margin. No single rigging fitting should ever be subjected to a load that
is greater than 100 lbs. Failure to heed this warning could result in injury or death!
VERIS Handle & Stand Socket
Model V-HSS
The V-HSS accessory for VERIS 2 models 6/26/8/28 attaches
to the loudspeaker enclosure's rear M6 threaded fittings to
create a stand socket mount and convenient carrying handle.
It is formed of zinc plated black powder coated steel. Perfect
for A/V professionals.
Seat Track Kit
Model STKIT
A Seat Track Kit is available that fits all models of VERIS 2
full-range loudspeakers. The STKIT provides a safe and
convenient means of suspending a single enclosure. By
purchasing multiple kits, one enclosure may be safely
suspended over another.
Ceiling Mount Kit
Model CMKIT
The Ceiling Mount Kit creates a hang point from a ceiling
surface. The CMKIT consists of a ceiling mount bracket and a
bolt that fastens to a U-yoke bracket or to one of several
optional loudspeaker brackets. It can be used with all full-
range VERIS 2 loudspeakers. Note: The yoke is sold
separately for VERIS 2 models 12/15/32/35. The yoke is
included with VERIS 2 models 6/26/8/28.
Vertical Flying Kit
Model VFKIT
The VFKIT for V2-12/15/32/35 full-range loudspeakers allows
two same-size enclosures to be flown at 45 and 60 degree
splay angles. To vertically array 3 same-size enclosures, use
2 VFKIT's. To vertically array 4 same-size enclosures, use 3
VFKIT's. Four eyebolts are included with each VFKIT.
VERIS 2 – Operation Manual - Page 30