Grinding Instructions - Weston 82-0301-W Manual

GRINDING INSTRUCTIONS

WARNING!
appliance, make sure the appliance is OFF and the PLUG IS REMOVED
FROM THE OUTLET/POWER SOURCE!
1. Follow the "Grinder Assembly Instructions" to fully assemble the Grinder including
the Tray.
NOTE: It is best to grind the meat using the coarse, 6 mm Grinding Plate first. If
a finer grind of meat is desired, run the coarse ground meat through the Grinder a
second time using the fine, 4 mm Grinding Plate.
2. Trim the meat of all cords, tendons, bones,
shot, etc.
3. For best results, be sure that all meat has
been chilled to between 32-34
grinding. DO NOT ALLOW MEAT TO SIT
OUT AT ROOM TEMPERATURE LONGER
THAN ABSOLUTELY NEEDED. Closely
follow the "Food Safety" instructions as outlined
by the USDA.
4. Cut meat into sizes small enough to fit into
the Feed Chute. Approximately 1" (2.5 cm)
cubes.
5. Place cubed meat to be ground into the Tray.
Do not overfill the Tray, place just enough meat
to leave the Feed Chute area open.
6. Place a dish or bowl to collect the ground
meat at the end of the Grinder Head (FIGURE
E).
7. Make sure the Grinder is in the OFF "O"
position. Attach the Grinder to the power
supply
8. Press "ON" the Grinder Button. Carefully
start feeding cubes of meat into the Feed
Chute. ONLY USE THE STOMPER TO
PUSH MEAT INTO THE HEAD, DO NOT
USE YOUR FINGERS OR ANY OTHER
OBJECT.
9. Press ON "I" the Grinder Button. Carefully
start feeding cubes of meat into the Feed
Chute. ONLY USE THE STOMPER TO
PUSH MEAT INTO THE HEAD, DO NOT
USE YOUR FINGERS OR ANY OTHER
OBJECT.
To avoid serious or fatal injury, NEVER reach into any Grinder inlet.
ALWAYS use the Stomper to push food into the Grinder Head.
Read & fully understand all instructions & warnings prior to use.
10
Before cleaning, assembling or disassembling the
F (0-1 C) before
o o
WARNING!
NEVER operate Grinder without the Tray secured in place.
FIGURE E
NOTE:
To prevent
overheating, do not
operate the Grinder for
more than 15 minutes
at a time.
Allow the Grinder
to cool
periodically.