Fcc Statement - Scosche WDQ2M Manual

This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference
received, including interlerence that may cause undesired operation.
This transmitter must not be co-located or operating in conjunction
with any other antenna or transmitter. Changes or modifications not
expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause hamiful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician
for help.
Radiation Exposure Statement: The product complies with the FCC/
IC RF Exposure for Low Power Consumer Wireless Power Transfer.
RF exposure limit set forth for an uncontrolled environment and are
safe for intended operation as described in this manual. The further
RF exposure that compliance was demonstrated at 10cm and greater
separation from the user body or set the device to lower output power
if such function is available.

FCC STATEMENT

7