Using The Continuous Recording Feature; Recording Manually - Alpine DVR-F200 Owner's Manual

3.3 Using the continuous recording feature

Connect the power cable to the product's DC-IN power port and then turn on the vehicle's electrical
accessories or start the engine. The status LED and the voice guide are turned on, and the continuous
recording starts.
During continuous recording, the product operates as follows.
Mode
Continuous During driving, videos are recorded in 1 minute segments and stored
recording in the "cont_rec" folder.
Incident When an impact to the vehicle is detected, a video is recorded for 20
continuous seconds, from 10 seconds before the detection to 10 seconds after
recording* the detection, and stored in the "evt_rec" folder.
* When an impact to the vehicle is detected during continuous recording, incident continuous recording starts with a
buzzer sound.
• Wait until the product is completely booted up after turning it on, and then begin operating the vehicle. The
video recording does not begin until the product is completely turned on (booted up).
• When incident continuous recording starts, the buzzer sounds as a notification. This function saves you
time when checking the status LED to know the operating status of the product.
• To enable recording, you must insert a memory card into the product.

3.4 Recording manually

You can record a scene you want to capture while driving and store it as a separate file.
To start manual recording, press the REC button. Then, manual recording will start with the voice guide.
During manual recording, the product operates as follows.
Mode
When you press the REC button, a video will be recorded for 1 minute, from
Manual
10 seconds before to 50 seconds after pressing the button, and stored in
recording
the "manual_rec" folder.
Operation description
Operation description
Autogoods "130"
Using recording features
Recording LED (REC)
(light on)
(flickers)
Recording LED (REC)
(flickers)
19