Inel YYGL35E-10/17 Instructions For Installation, Programming And Operation

DRIVE WITH OBSTACLE DETECTOR AND ELECTRONIC END STOP SWITCHES
Instructions for installation, programming and operation
Basic guidelines
The tubular motor YYGL35E-10/17/YYGL45E-20/15 with obstacle detection can be safely installed and used provided
all of the following instructions of installation and use as well as obligatory health and safety regulations are adhered to.
The installation and repairing of electrical equipment should be carried out only by persons with app ropriate legal
qualifications.
Reconstructing or making changes to the tubular motor YYGL35E-10/17/YYGL45E-20/15 with obstacle detection is
forbidden. During the guarantee period repairs only the manufacturer may carry out repairs. Even after the guarantee
period has expired only original parts and accessories may be used.
The guarantee is only valid when the tubular motor YYGL35E-10/17/YYGL45E-20/15 with obstacle detection has been
used in accordance with the manufacturer's instructions. The boundary values given in the technical specifications must
NOT be exceeded under any circumstances.
Supplementary safety regulations
When installing, using or carrying out maintenance work all binding health and safety regulations should be followed.
Particular attention should be paid to the following:
1. European standards
2. Fire regulations
3. Accident avoidance
GENERAL COMMENTS REGARDING HAZARDS AND SAFETY PRECAUTIONS
The following comments serve as general guidelines to the application of INEL drivers with other devic es.
These guidelines must always be adhered to when installing and operating these devices.
Warning – this signal warns of possible damage to the control system or other equipment if appropriate
safety measures are not taken.

Before installing the control system and setting the end switches check all bolt connections are properly fastened.
Danger – this signal indicates danger to the user's life and health if appropriate safety measures are not taken.
 Follow all health and safety regulations relevant to the equipment (e.g. gates, roller blinds) used.
 When changing fuses the equipment must be first disconnected from the mains, the fuses changed and only then
may the equipment be reconnected to the mains.
 INEL equipment connected to the mains beyond a building's safety fuse system needs to be installed with its own
safe disconnecting devices (e.g. safety fuses and safety switches) in such a way so as to ensure that all the units
may be easily and safely cut off from the mains.
 Electric wiring and cables should be regularly checked to ensure the insulation is intact and there are no breaks in
the wire.
 If any damage to the wiring is found, the unit should be immediately disconnected from the mains and the
damaged wiring replaced.

Before connecting any equipment, one should first make sure that it is adapted to be used with the local voltage in

the mains.
 Do not allow children to play with any of the control devices.
 Keep all remote control devices out of the reach of children.
 Observe the opening or shutting of the blinds, shutters, awnings or gates and ensure all persons stand clear
until the operation is completed.
 Control system operators need to undergo preliminary instruction and training and also be made aware of all the
potential dangers that can be encountered. A person should only be authorized to use the control system only
once the employer, administrator or owner is satisfied that that person has been properly instructed.
YYGL35E-10/17
YYGL45E-20/15
PERSONAL SAFETY WARNING