Safety Warnings - S&P METEOR-ES N Instructions For Use Manual

ENGLISH
INTRODUCTION
• Thank you for placing your trust in S&P by purchasing this "box-type fan", which has been
manufactured in accordance with technical safety regulations and compliance with current
EC standards.
• Before using this product please read the instructions carefully, as they contain important
information for your safety during use and maintenance. Keep these instructions at hand
for future reference.
• Please check that the appliance is in perfect condition when you unpack it, as all factory
defects are covered by the S&P guarantee.

SAFETY WARNINGS

• Make sure the electrical supply voltage / frequency coincides with the data on the specifi-
cations plate located at the rear of the device.
• Do not hang this appliance from the wall or ceiling.
• Do not use it close to baths, showers, swimming pools or saunas.
• The equipment for disconnection, which must be incorporated into a fixed installation for its
disconnection from the electrical supply, should have at least a 3 mm gap between all poles
so that it provides a complete disconnection in compliance with the Category III excess
voltage conditions.
• If the cable is damaged, it should be replaced by specialised personnel or S&P post-sales
service, so as to avoid any possibility of damage or harm.
• Do not clean the appliance while it is in operation and do not immerse it in water.
• Do not operate the appliance with wet hands.
• Do not unplug it by pulling the cable.
• Before disconnecting the appliance from the mains, make sure the speed selector is set to 0.
• Do not insert any object through the protection grille.
• Do not place the fan close to sources of heat or hot surfaces.
• This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the appliance by a person responsible for
their safety.
• Children must be under watch to avoid that they could play with the product.
START UP
The appliance will start working if the timer is set to ON and the speed selector is in any po-
sitive position (1,2 or 3).
4