Loading The Nailer - Makita AN610H Instruction Manual

1 2
009180
If nails are driven too deep, turn the adjuster clockwise.
If nails are driven too shallow, turn the adjuster
countercolockwise.
The adjustable range is 0 - 6 mm. (One full turn allows
0.8 mm adjustment.)
Hook
CAUTION:
Always disconnect the hose when hanging the tool
•
using the hook.
Never hang the tool on a waist belt or like.
•
Dangerous accidental firing may result.
1
009181
The hook is convenient for hanging the tool temporarily.
This hook can be installed on either side of the tool.
When changing the installation position, remove the
screw with a screwdriver. Install the hook on another
side for installation and then secure it with the screw.
Use the nose adapter
CAUTION:
Always disconnect the hose before installing or
•
removing the nose adapter.
009182
1. Too deep
3
2. Flush
3. Too shallow
1. Hook
1. Hole
2. Protrusion
3. Nose adapter
1
2
3
If you like to protect the surface of worpiece, attach the
nose adapter of contact trip.
When nailing workpieces with easily-marred surfaces,
use the nose adapter. To attach the nose adapter to the
contact arm, press it onto the contact arm until the
protrusion in three places inside the nose adapter fit in
three holes in the contact arm.
ASSEMBLY
CAUTION:
Always disconnect the air hose before loading the
•
nailer.

Loading the nailer

CAUTION:
Make sure that the coil support plate is set to the
•
correct step for used nails.
009174
Disconnect the air hose from the tool. Select nails
suitable for your work. Depress the latch lever and open
the door and magazine cap.
Select nails suitable for your work. Depress the latch
lever and open the magazine cap.
Lift and turn the coil support plate so that the arrow with
nail size indicated on the coil support plate will point to
the corresponding graduation increment marked on the
magazine. If the tool is operated with the coil support
plate set to the wrong step, poor nail feed or malfunction
of the tool may result.
3
009175
Place the nail coil over the coil support plate. Uncoil
enough nails to reach the feed claw. Place the first nail in
the driver channel and the second nail in the feed claw.
6
1. Magazine cap
2. Latch lever
3. Door
1
2
3
1. Adjustfit
2. Change plate
1
3. Arrow
2