Page 1
INSTRUCTION MANUAL Construction Nailer AN610H 009172 WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
2 “x 4” housing. EC Declaration of Conformity ENG102-3 Makita Corporation responsible Noise manufacturer declare that the following Makita The typical A-weighted noise level determined according machine(s): to EN792: Designation of Machine: Sound pressure level (L ) : 86 dB(A)
000230 Tomoyasu Kato etc.; they will ignite and explode, causing serious Director injury. Makita Corporation The area should be sufficiently illuminated to • 3-11-8, Sumiyoshi-cho, assure safe operations. The area should be clear Anjo, Aichi, JAPAN and litter-free.
Page 4
Do not modify tool without authorization from • vehicles and wagons. Makita. Do not permit those uninstructed to use the tool. Ask Makita's Authorized service centers for • • Make sure no one is nearby before nailing. Never periodical inspection of the tool.
INSTALLATION frequency may cause a decrease in the driving capability of the tool. Selecting compressor Lubrication (L/min) 004295 To insure maximum performance, install an air set (oiler, regulator, air filter) as close as possible to the tool. (times/min) Adjust the oiler so that one drop of oil will be provided for Nailng frequency every 30 nails.
If you like to protect the surface of worpiece, attach the 1. Too deep nose adapter of contact trip. 2. Flush When nailing workpieces with easily-marred surfaces, 3. Too shallow use the nose adapter. To attach the nose adapter to the contact arm, press it onto the contact arm until the protrusion in three places inside the nose adapter fit in three holes in the contact arm.
Place other uncoiled nails on feeder body. Close the No. (2) method is for continuous nailing. magazine cap slowry until it lock after checking to see CAUTION: that the nail coil is set properly in the magazine. However when the tool is set to the "Intermittent •...
Page 8
Slanted nailing may cause nails to strike back, injuries.Do not nail directly on the concrete or do causing serious injuries. not use to fasten directly the steel plate to the When fastening a corrugated zinc plate on the concrete. Failure to do so may cause concrete •...
Page 9
CAUTION: 1. Cap Always disconnect the hose before cutting off the • sheet. Tear off the output sheet in the direction of the arrow when using the sheet collated nails. MAINTENANCE CAUTION: 009193 Always disconnect the air hose from the tool before •...
Page 10
Only use accessory or attachment for its stated purpose. If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. Nails • Air hoses • Safety goggles •...
Page 12
Makita Corporation Anjo, Aichi, Japan 884844B220...