Table of Contents
Advertisement
Do not turn the adjuster too much, or the adjuster may
get stuck.
Indication lamp
Color of the indication lamp means the followings.
Blinking green: Normal status
Blinking red: Need to recharge the battery cartridge
Lighting-up-red:
Recharge
Nailing cannot be performed due to no remaining
battery capacity.
Blinking orange after blinking green and red
alternately: Fault detection is running. Remove and
reinsert the battery cartridge to reset. If fault detection is
running again, it is malfunction condition. Ask your local
Makita service center to repair it.
Hook
CAUTION:
Always remove the battery when hanging the tool. Do
not hang the tool to your belt.
013156
The hook is convenient for hanging the tool temporarily.
The hook can be set in two positions according to where
the tool will be hung.
To change the hook position, push its feet in from both
sides and shift to another position.
ASSEMBLY
CAUTION:
Always remove the fuel cell and the battery
•
cartridge before carrying out any work on the tool.
Loading the nailer
013157
Insert a strip of nails into the slit in the rear of the
magazine. The nails stop at the entrance of the
the
battery cartridge.
1. Hook
1
1. Button
1
magazine because of the nail stopper. Unlock the
magazine by pressing the button of the nail stopper to
insert the nails.
1
013158
Pull the pusher lever with pressing the pusher button all
the way to the rear of the magazine. Then release the
pusher button, and return the pusher lever to the end of
the strip gently.
Removing nails
1
013159
Pull the pusher lever and push the pusher button to
release the nail supporter, and then return the pusher
lever to the top with pushing the pusher button.
Slide the nails toward the rear of the magazine. The
nails stop at the entrance of the magazine because of
the nail stopper. Unlock the magazine by pressing the
button of the nail stopper to remove the nails.
Changing the magazine (optional accessory)
013165
A magazine with different length is available as optional
accessory.
To change the magazine, loosen the bolt and remove
the magazine. Then install the new magazine. And
fasten the bolt on the magazine.
9
1. Pusher lever
1. Pusher lever
2. Nail stopper
2
1. Bolt
1
Advertisement
Table of Contents
