Installation; Functional Description; Adjusting The Nailing Depth - Makita AN610H Instruction Manual

INSTALLATION

Selecting compressor
(L/min)
Nailng frequency
009173
The air compressor must comply with the requirements
of EN60335-2-34.
Select a compressor that has ample pressure and air
output to assure cost-efficient operation. The graph
shows the relation between nailing frequency, applicable
pressure and compressor air output.
Thus, for example, if nailing takes place at a rate of
approximately 50 times per minute at a compression of
1.76 MPa (17.6 bar), a compressor with an air output
over 90 liters/minute is required.
Pressure regulators must be used to limit air pressure to
the rated pressure of the tool where air supply pressure
exceeds the tool's rated pressure. Failure to do so may
result in serious injury to tool operator or persons in the
vicinity.
Selecting air hose
004294
Use a high pressure resistant air hose.
Use an air hose as large and as short as possible to
assure continuous, efficient nailing operation.
CAUTION:
Low air output of the compressor, or a long or
•
smaller diameter air hose in relation to the nailing
Lubrication
004295
To insure maximum performance, install an air set (oiler,
regulator, air filter) as close as possible to the tool.
(times/min)
Adjust the oiler so that one drop of oil will be provided for
every 30 nails.
When an air set is not used, oil the tool with pneumatic
tool oil by placing 2 (two) or 3 (three) drops into the air
fitting. This should be done before and after use. For
proper lubrication, the tool must be fired a couple of
times after pneumatic tool oil is introduced.
009192

FUNCTIONAL DESCRIPTION

CAUTION:
•

Adjusting the nailing depth

CAUTION:
•
009179
5
frequency may cause a decrease in the driving
capability of the tool.
Always disconnect the air hose before adjusting or
checking function on the tool.
Always disconnect the hose before adjusting the
depth of nailing.
2
3
1. Adjuster
2. Shallow
3. Deep
1