Specifications - Makita AN610H Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Min. hose diameter
Dimensions (L X H X W)
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
Wear safety glasses.
･
Do not use on scaffoldings, ladders.
Intended use
The tool is intended for the preliminary interior work such
as fixing floor joists or common rafters and framing work
in 2 "x 4" housing.
Noise
The typical A-weighted noise level determined according
to EN792:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration emission value determined according to
EN792 :
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
Model
Air pressure
Nail length
Nail capacity
Net weight
) : 86 dB(A)
pA
) : 99 dB(A)
WA
2
) : 3.0 m/s
h
2
Sheet-collated coil nail 32 mm - 65 mm
Wire-collated coil nail 250 pcs,300 pcs,400 pcs
END106-2
WARNING:
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
ENE059-1
is running idle in addition to the trigger time).
For European countries only
EC Declaration of Conformity
ENG102-3
We Makita
manufacturer declare that the following Makita
machine(s):
Designation of Machine:
Construction Nailer
Model No./ Type: AN610H
are of series production and
Conforms to the following European Directives:
ENG233-2
98/37/EC until 28th December 2009 and then with
2006/42/EC from 29th December 2009
And are manufactured in accordance with the following
standards or standardised documents:
EN792
The technical documentation is kept by our authorised
ENG901-1
representative in Europe who is:
Makita International Europe Ltd,
Michigan, Drive, Tongwell,
Milton Keynes, MK15 8JD, England
2
AN610H
0.98 - 2.26 MPa (9.8 - 22.6 bar)
Wire-collated coil nail 32 mm - 65mm
Sheet-collated coil nail 200 pcs
5.0 mm
282 mm X 277 mm X 136 mm
1.9 kg
Corporation as
ENH003-11
the responsible