Culligan BAEMUV1SHSK SSA User Manual page 13

TROUBLESHOOTING (BOTTLE-LESS)
PROBLEM
Water does
not dispense.
Cold water does
not dispense.
Hot water does
not dispense.
Dispenser is noisy
during operation.
Water leaks from the
water dispense point.
Water is dripping out
of the dispenser and
onto the floor.
The water being
dispensed has
a strange taste.
POSSIBLE CAUSE
Dispenser is unplugged.
Main power supply is off.
The lower cabinet door is open.
Strainers are clogged.
Water supply switch is in the wrong
position.
Cooling system switch is OFF.
Too much cold water consumed
in a short period of time.
The ventilation around the
dispenser is insufficient.
System has malfunctioned.
Water supply switch is in the wrong
position.
Hot water switch is OFF.
Too much hot water has been
consumed in short period of time.
System has malfunctioned.
Water supply switch is in the wrong
position.
The dispenser is not level.
Dispenser is touching other objects.
The buttons are stuck down.
The water dispense point
has been damaged.
The hot tank drain cap is
not fastened properly.
The hot or cold water tank is leaking.
This is not uncommon
with new dispensers.
Dispenser requires cleaning.
Filter is old or water supply is tainted.
Plug the dispenser into a grounded
Re-establish main power supply.
Close door and allow time for the
solenoid valve to fill the reservoirs.
Remove strainers and clean.
Make sure that the water supply switch is set to
the correct water supply position.
Wait 15 minutes for the water to cool.
Provide at least 6 in (15 cm) of clearance
on all sides of the dispenser.
Turn off water supply valve and unplug
the dispenser. Contact dealer.
Make sure that the water supply switch is set to
the correct water supply position.
Turn hot water switch ON.
Wait 15 minutes for the water to heat.
Turn off water supply valve and unplug
the dispenser. Contact dealer.
Make sure that the water supply switch is set to
the correct water supply position.
Place the dispenser on a level, flat surface.
Move dispenser away from other objects.
Check for foreign objects in the button area.
Contact Culligan Customer Service.
If the seal inside the drain cap is torn
or damaged then replace with a new one.
Turn off water supply valve and unplug
the dispenser. Contact dealer.
The taste usually goes away after
the first several gallons have been used.
(See CLEANING AND MAINTENANCE)
Replace filter and check water supply line for
13
SUGGESTION
GFCI power outlet.
Turn cooling switch ON.
844-787-3148
Tighten the drain cap.
Clean the waterways.
taste.