Advertisement
Quick Links
Quick Start EVK-G35 / EVK-G45
3
7
2
UBX-13002850 - R03
8
SW403
6
Setup
Download and install the EVK-G35/EVK-G45 software (and
documentation) from www.u-blox.com/evk-search.
See installation notes on the back of this card.
1.
Insert SIM card in SIM Card Holder.
2.
Connect GSM antenna with SMA connector to GSM
4
Antenna (SMA female connector).
3.
Connect GPS antenna to GPS Antenna (if required).
5
4.
Connect power adapter to 9 – 18 V Power Input connec-
tor (J400) (+12 V). LED DL401 is blue.
5.
To supply power to the board, turn Main Power (SW400)
switch to ON position. LED DL400 is green.
6.
To switch on the cellular module, press the Module
Power ON (SW302) button (the power on is triggered by
a rising edge).
Allowed connections via UART to cellular module:
7.
Connect USB cable to mini USB connector (USB UART
J501). Switch SW403 must be in position MINIUSB.
8.
Connect RS232 cable to RS232 connector (UART
1
RS232 J500). Switch SW403 must be in position DB9.
Copyright © 2018, u-blox AG
Advertisement
Related Manuals for u-blox EVK-G35
Summary of Contents for u-blox EVK-G35
- Page 1 Quick Start EVK-G35 / EVK-G45 Setup SW403 Download and install the EVK-G35/EVK-G45 software (and documentation) from www.u-blox.com/evk-search. See installation notes on the back of this card. Insert SIM card in SIM Card Holder. Connect GSM antenna with SMA connector to GSM Antenna (SMA female connector).
- Page 2 Windows Device Manager). The serial port for AT commands is available over the first For more information about the EVK-G35 and EVK-G45, numbered COM port opened by the driver. contact your nearest u-blox support: Refer to the User Guide under the “Documentation &...