Table of Contents
Advertisement
WARNING
Blades are sharp. When handling the blade assembly,
wear non-slip, heavy-duty protective gloves. Do not
place your hand or fingers between blades or in any
position where they could get pinched or cut. Never
touch blades or service the product with the spark plug
wire connected.
WARNING
Do not, at any times, let brake fluids, solvents, gasoline,
petroleum-based products, penetrating lubricant, etc.,
to come in contact with plastic parts. Chemicals can
damage, weaken, or destroy plastic which may result in
serious personal injury.
WARNING
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible
serious personal injury.
■ You may make adjustments and repairs described in
this manual. For other repairs, contact the authorised
service centre.
■ After each use, clean the body and handles of the
product with a soft, dry cloth.
■ After each use, clean the debris from the blades
with a stiff brush, and then carefully apply a rust
preventative lubricant before refitting the blade
protector. The manufacturer recommends you to
use a rust preventative and lubricant spray to apply
an even distribution and reduce the risk of personal
injury from contact with the blades. For information
about suitable spray product, check with your local
authorised service centre.
■ You may wish to lubricate the blades lightly before use
if necessary using the above method.
■ Check all nuts, bolts, and screws at frequent intervals
for proper tightness to ensure the product is in safe
working condition. Any part that is damaged should be
properly repaired or replaced by an authorised service
centre.
REPLACING THE BLADES
■ Periodically inspect the blades for damage and wear.
If any blades are damaged, they should be properly
repaired or replaced by an authorised service centre.
English (Original Instructions)
LUBRICATING THE BLADE
See figure 5.
■ For easier operation and longer blade life, lubricate the
■ Stop the engine and disconnect the spark plug wire.
■ If you will be using the hedge trimmer for an extended
CLEARING A BLOCKAGE
■ Stop the engine and wait for all moving parts to stop.
■ Disconnect the spark plug wire.
■ The blades are sharp. Wear heavy-duty gloves when
■ Carefully clear away the blockage or debris from
TRANSPORTATION AND STORAGE
■ Stop the engine and allow it to cool before storing or
■ Clean all foreign material from the product.
■ Cover the blade with the blade protector (scabbard).
■ Drain all fuel from the tank into a container approved
■ Run the engine until it stops. This will remove all fuel
■ Store the product in a cool, dry, and well-ventilated
■ Keep away from corrosive agents such as garden
■ Do not store outdoors.
■ When transporting the product in a vehicle, secure
■ Never carry or transport the product while the engine
■ Abide all government and local regulations for the
5
hedge trimmer blade before and after each use.
Lay the hedge trimmer on a flat surface. Apply light
weight product lubricant along the edge of the top
blade.
period, it is advisable to lubricate the blade during use.
NOTE: Do not lubricate while the hedge trimmer is
running.
working near the blades.
around the blades or other moving parts.
transporting.
for petrol. Remember to properly replace and tighten
the fuel cap.
that could become stale and leave varnish and gum in
the fuel system.
place that is inaccessible to children and well away
from sources of ignition.
chemicals and de-icing salts.
it against movement or falling to prevent injury to
persons or damage to the product.
is running.
safety storage and handling of petrol.
Advertisement
Table of Contents
