Silvercrest SWW 1500 A1 75784 Operating Instructions Manual page 47

Overheating protection
GB
Frost protection function
Topple over protection
44
♦ When the switch-on time arrives and the room temperature is below the set
nominal temperature, the appliance switches on with the higher heating
power (HIGH).
♦ Press the button AUTO ON
the switch on time. In the display
With excessive temperature rise the device automatically switches off and in the
display appears
Should this occur...
♦ Switch the device off at the main switch POWER
plug from the wall socket. Allow the device to cool down for a few minutes
♦ After the cause of the overheating has been removed, i.e. a covered heating
element, the device can be switched on again.
The device is equipped with a frost protection function which automatically switches
to the high heat output (HIGH) as soon as the room temperature falls below 7°C.
When the room temperature has reached 10°C the appliance automatically
switches back to standby mode.
♦ Activate the main switch POWER
into standby operation. In the display
function lights up.
The device now switches on if the room temperature drops below 7°C.
In the display the symbol for the frost protection function
The device is equipped with topple over protection which automatically switches
the heating element 9
sounds for 1 minute.
Handling and operation
and/or
2 11
the indicator AUTO ON
.
6 to switch the device on and to shift
the symbol for the frost protection
off if the device topples over. In addition a warning tone
again if you want to deactivate
goes out.
6 and pull the mains power
blinks.
SWW 1500 A1