Silvercrest SWW 1500 A1 75784 Operating Instructions Manual page 45

Handling and operation
GB
Switching the device on and off
Heating operation
Setting the nominal temperature
42
NOTICE
► All functions can be switched both with the buttons on the device and with
the remote control.
In this section you receive important information for the handling and operation
of the device.
With the main switch POWER
mains power.
♦ Firstly switch the main switch POWER
no longer operating the device.
♦ Activate the main switch POWER
appears briefl y
area of the integrated temperature sensor. The device is now in standby mode.
In the display the symbol for the frost protection function
♦ Press the button POWER/MODE
with the low heat output (LOW). In the display
♦ Press the button POWER/MODE
output (HIGH). In the display
♦ Press the button POWER/MODE
display , the indicator LOW appears and the nominal temperature blinks
for 5 seconds.
♦ Whilst the nominal temperature is blinking in the display
the buttons +/- 4
15°C to 35°C. Each press of the button +/-
reduces the nominal temperature by 1°C. Wait approx. 5 seconds until the
nominal temperature is continuously shown in the display
now saved and the heating element
♦ Press the button POWER/MODE
high heat output (HIGH). In the display
the nominal temperature blinks for 5 seconds.
Handling and operation
6 the device is completely disconnected from the
6 on and/or lastly off when you are
to switch the device on. In the display
6
and subsequently the current device temperature in the
3 and/or
3 and/or
appears .
3 and/or
and/or to set the desired nominal temperature from
13
9 switches on.
3 and/or
lights up.
. The device switches on
12
appears .
again to set the high heat
12
repeatedly until, in the
12
press one of
and/or increases or
4 13
. The setting is
again if you want to set the
12
appears the indicator HIGH and
SWW 1500 A1