Troubleshooting - Swann Dirtmaster Pro SC17320N Manual

3. Rinse out the carpet brush (6) thoroughly under warm, running water.
Cleaning the Upholstery Nozzle
E
E
F
F
Problem
The device does not work.
The stain is not removed.
SC17320N_IMindd.indd 12
CLEANING THE DEVICE
4. Allow the carpet brush (5) to dry completely and
insert it back into the main unit. Make sure it is in the
correct position (see picture). Press together the
locking device and press it into the recess on the bot-
tom of the main unit. It must engage audibly.
1. Clean the upholstery nozzle. To do this, press the
button on the base of the upholstery nozzle (E) and
detach the it from the hose (see picture).
2. If necessary, remove the brush insert from the uphol-
stery nozzle. To do this, press down the button on the
bottom of the upholstery nozzle (F) and pull out the
brush insert
3. Rinse out the upholstery nozzle and brush insert
thoroughly with warm water.
4. Allow all parts to dry completely before assembling
them.

TROUBLESHOOTING

Cause/Solution
• Is the plug inserted in the socket correctly?
• Is the socket defective? Try another plug
socket.
• Check the fuse of the mains connection.
• Has the overheating protection been acti-
vated? Let the device cool down for approx. 60
minutes and then switch it on again using the
On/Off switch.
• The stain is too stubborn or too old. Treat
the stain specifically with a carpet cleaning
product.
12
27/02/2019 08:35