IMPORTANT SAFETY INSTRUCTIONS When using your Cyclonic Upright Vacuum, the following basic safety precautions should be observed: Never vacuum wet surfaces, pick up wet objects or use in wet conditions. Always disconnect the vacuum from the electrical supply before attempting any maintenance.
Electrical Safety Before switching on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate. This product is designed to operate on 220 – 240V AC; 50Hz. Connection to any other power source may damage the unit. This product may be fitted with a non –...
Page 6
OPERATING INSTRUCTIONS On/off switch Assembling Your Vacuum Cleaner The On/Off slide switch is sited on the handle 1. Carefully unpack all components and set aside the packaging. of the vacuum 2. Lift vacuum body to the upright position. How to Start 3.
Page 7
OPERATING INSTRUCTIONS Carpet Height Adjustment Using and Storing the This upright vacuum can be used on Accessories multiple types of carpet, bare floors and The vacuum is designed with a built-on upholstery with attachments. tool caddy for the accessories. To select a carpet height setting: 1.
Page 8
OPERATING INSTRUCTIONS Using the Air Driven Turbo Brush Remove the hose connector from the side of the unit and attach the hose handle. (Fig. 1. Pull out the air driven turbo brush from the storage compartment. (Fig. 10) If additional length is required, attach the hose handle to the telescopic tube and then attach Fig.
Page 9
OPERATING INSTRUCTIONS Cleaning Air Driven Turbo Brush cont. Cleaning the Dust-Bin Inspect the turbine wheel and air passage for debris and The dust-bin can be washed in blockages. Remove debris if lukewarm water. Do not use present. strong detergents. Ensure that Inspect the rotating brush for the dust-bin is fully dry before built-up hair or string.
Page 10
OPERATING INSTRUCTIONS Cleaning the Debris Screen 1.To remove the debris 1. Clean the HEPA filter screen from the dust-bin: after every use with With the trap door open, the built in pleat grasp the frame within the cleaner. Fig. 19 dust –bin and turn Turn the knob clock-wise and remove.
Page 11
3. With a screw driver remove the five (5) screws on the bottom plate. (Fig. 25) Fig. 28 Note: The drive belt is consumable part. Please call 01733 404 709 to buy genuine Fig. 25 Swan spare parts.
Page 12
OPERATING INSTRUCTIONS Cleaning & Changing the Belt Motor Thermostat Please Note: Important: This unit is equipped with a The agitator end caps show an motor protective thermostat. If for some reason vacuum cleaner should arrow that indicates the correct overheat, the thermostat will automatically direction the agitator must be turn the vacuum off.
PROBLEM SOLVING This appliance was inspected thoroughly and was in good operating condition when it was shipped from the factory. If a minor problem occurs, it usually can be solved quite easily. Therefore, this checklist is provided for your convenience. P R O B L E M P O S S I B L E C A U S E P O S S I B L E...
WASTE ELECTRICAL RECYCLING This symbol indicates that this product is classed as Electrical or Electronic Equipment and should not be disposed of with other household waste. The Waste Electrical and Electrical Equipment (WEEE) Directive has been introduced across the European Union: •...
● If the vacuum cleaner is malfunctioning or the power cord is damaged in any way, don’t use the vacuum cleaner. The vacuum cleaner must be repaired by a qualified service agent. ● If you have any problems with your vacuum cleaner, please call the Swan helpline: 01733 404703. Available Spares:...