Troubleshooting - Swann Eureka MULTI-CLEAN SC15810N Manual

filter cotton
Remove
Problem
Motor will not start
Not enough
suction power
SC15810_12_IM.indd 7
GET TO KNOW YOUR VACUUM
Illustration of the main unit
2
Main Brush. Step down the pedal of main brush to extend or Push
retract the bristles. As a general rule: extended for hard floor,
retract for carpeted floors.
Pet Turbo Tool (SC15812N only) Connect to end of the hose
in place of the Main Brush to make short work of pet hairs etc.

TROUBLESHOOTING

• Make sure cleaner is connected to mains supply
• Empty dust tank and clean the filters.
• Remove anything that may be clogging the tubes or main brush
THE VACUUM MUST BE SWITCHED OFF WHEN REMOVING DEBRIS
7
Periodically remove and
clean the filter assembly.
PLEASE NOTE: it must be
COMPLETELY dry before
refitting.
Water inside the vacuum
could cause malfunction.
1
3
Push
Pull out the power cord to connect the power
supply:When you see the red mark on the power
cord, do not pull the power cord outward.
2
Press the ON/OFF button:Control the start
and stop of the vacuum cleaner.
3
Press the take up button: The power cord
1
is automatically rolled back into the machine.
Pull
Solution
Dust tank maintenance
Open the dust tank: Gently lift the
dust tank open button, and then lift
up to open the dust tank cover.
Separate
Filter disassembly and cleaning: R
put the filter and its bottom cover
Take out the fi
1. The filter parts can be put back for use only
2. All parts must be properly installed, otherwi
3. Water is not allowed to penetrate into the v
may cause product failure.
15/10/2018 12:14