IMPORTANT SAFETY INSTRUCTIONS When using your Cyclonic Upright Vacuum, the following basic safety precautions should be observed: Never vacuum wet surfaces, pick up wet objects or use in wet conditions. Always disconnect the vacuum from the electrical supply before attempting any maintenance.
Electrical Safety Before switching on, make sure that the voltage of your electricity supply is the same as that indicated on the rating plate. This product is designed to operate on 220 – 240V AC; 50Hz. Connection to any other power source may damage the unit. This product may be fitted with a non –...
Page 5
GETTING TO KNOW YOUR BAGLESS CYCLONIC UPRIGHT Upper Handle 11. Furniture Guard On/Off Switch 12. Crevice tool Accessory Cover Release 13. Handle Release Dust tank release 14. Small brush Dust tank 15. Upholstery tool Carpet Height Adjustment Knob 16. Extension tube (x2) Main body 17.
Page 6
OPERATING INSTRUCTIONS Assembling Your Vacuum Cleaner Using the Attachments 1. Place the vacuum in its upright position. Make Note: Do not plug the power cord into an sure that the vacuum cleaner is NOT plugged electrical outlet until the vacuum is fully into the electrical outlet when adding or assembled.
Page 7
OPERATING INSTRUCTIONS Carpet Height Adjustment Removing & Emptying the Dust-bin This upright vacuum can be used on multiple Warning: To reduce the risk of electric shock, the types of carpet, bare floors or upholstery with tool power cord must be disconnected before attachments.
Page 8
OPERATING INSTRUCTIONS Please Note: The white HEPA filter will discolour Cleaning the HEPA Dust Cup Filter IMPORTANT, Please Note: The Washable “Tap over time - This is NORMAL and will NOT affect Clean” HEPA Dust-bin Filter will stop most dust the performance of the filter.
Page 9
OPERATING INSTRUCTIONS Changing & Cleaning the Pre- Motor Filter Changing & Cleaning the Exhaust Filter (cont.) Warning: To reduce the risk of electric shock, the 3. Pull the exhaust filter out. (Fig. 15) power cord must be disconnected before removing 4.
Page 10
OPERATING INSTRUCTIONS 5. Use a flat bladed screw driver to remove the Cleaning & Changing the Belt agitator. Warning: To reduce the risk of electric shock, the 6. Slide the flat head screw driver into the left power cord must be disconnected before side of the power head between the agitator removing the dust-bin, dust-bin filter, changing and the power head housing and lift.
Page 11
OPERATING INSTRUCTIONS Motor Thermostat Important: This unit is equipped with a motor protective thermostat. If for some reason the vacuum cleaner should overheat, the thermostat will automatically turn the unit off. Should this occur: • Push the On/Off button once. •...
PROBLEM SOLVING This appliance was inspected thoroughly and was in good operating condition when it was shipped from the factory. If a minor problem occurs, it can usually be solved quite easily. Therefore, this checklist is provided for your convenience. P R O B L E M P O S S I B L E C A U S E P O S S I B L E...
WASTE ELECTRICAL RECYCLING This symbol indicates that this product is classed as Electrical or Electronic Equipment and should not be disposed of with other household waste. The Waste Electrical and Electrical Equipment (WEEE) Directive has been introduced across the European Union: •...