Related Manuals for Swann Eureka SC15836N
Summary of Contents for Swann Eureka SC15836N
- Page 1 Help line: 0333 220 6050 TMULTIFUNCTION UPRIGHT VACUUM Model: SC15836N MULTIFUNCTION PET Model: SC15838N v1.0 SC15836_38_IM.indd 1 12/10/2020 14:43...
-
Page 2: Important Safeguards
IMPORTANT SAFEGUARDS ! Follow caution information wherever you see this symbol. When using an electrical appliance, basic precautions should always be followed, including the following: READ ALL INSTRUCTIONS BEFORE USING THIS VACUUM CLEANER Failure to follow the warnings and instructions may result in electric shock, fire and/or serious injury. WARNING This vacuum cleaner is intended for household use only and NOT for commercial or industrial use. - Page 3 IMPORTANT SAFEGUARDS • Always protect the power cable from heated surfaces and open flames. • This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the vacuum cleaner in a safe way and understand the hazards involved.
- Page 4 UNPACKING Carefully unpack and inspect your new Eureka | Swan vacuum cleaner for shipping damage. Each unit is tested and thoroughly inspected before shipping. For instructions regarding any shipping damage, call the Eureka | Swan Customer Service HELPLINE at 0333 220 6050 immediately. Make sure your vacuum cleaner is switched off and unplugged when cleaning, removing or refitting parts.
-
Page 5: What's In The Box
WHAT’S IN THE BOX? Hose Vacuum cleaner Important safeguards Upper Cord Hook Lower Cord Hook Pet Brush (SC15838N only) Dusting brush Upholstery tool Crevice tool Flexible telescoping crevice tool Handle 2-in-1 upholstery tool SC15836_38_IM.indd 5 12/10/2020 14:43... - Page 6 GET TO KNOW YOUR VACUUM Click! Vacuum cleaner with dust Slide handle into top of Insert bent end of hose into Store accessories on back of tank. vacuum cleaner. Push down opening at back of dust tank. vacuum cleaner. until it clicks. Twist hose clockwise to lock.
- Page 7 GET TO KNOW YOUR VACUUM Handle with wand Cord clip Turbo/pet brush SC15838N only Hose retainer Handle release latch Dust tank release button Dusting brush Carry handle Upholstery tool Upper cord wrap Dust tank lid Dust tank latch Hose Dust tank Crevice tool Power cord Lower cord wrap...
- Page 8 OPERATION When using on steps: Position as shown below. Do not allow the brush roll to come into contact with edge of the stair carpet or damage could occur. Do not pull on the hose. Brush roll Step SC15836_38_IM.indd 8 12/10/2020 14:43...
-
Page 9: Operation
OPERATION Plug power cord into outlet. Turn height adjustment knob to Step on power switch to turn vacuum cleaner on. Step on again pile carpet. to turn off. Empty dust tank after every use Step on handle release to Press release button and lift off To empty debris, press lever to lower handle into position for dust tank. -
Page 10: Using Accessories
USING ACCESSORIES C A U T I O N When using tools, always place handle in Click! upright position. Make sure vacuum cleaner is turned off while attaching tools. • Place vacuum in upright position. • Turn height adjustment knob to highest position. -
Page 11: Maintenance
MAINTENANCE Dust Tank – Empty after each use Click! Press release button and lift Hold dust tank over wastebasket Close bottom lid until it off dust tank. and press lever to release clicks. bottom lid. Debris will empty. Pull dust tank latch to lift up dust tank lid. -
Page 12: How To Clear A Blockage
MAINTENANCE How to clear a blockage C A U T I O N Make sure vacuum is turned off and power cord is unplugged. if no suction at end of hose, check to be sure air path is not blocked. •... -
Page 13: How To Maintain Brushroll
MAINTENANCE How to maintain brushroll C A U T I O N Make sure vacuum is turned off and power cord is unplugged. • Step on handle release to lower handle. • • To avoid unnecessary service calls, check brushroll for debris. •... -
Page 14: How To Replace Brushroll Or Belt
MAINTENANCE How to replace brushroll or belt C A U T I O N Make sure vacuum is turned off and power cord is unplugged. • Step on handle release and lay vacuum cleaner face down. • Use Phillips screwdriver to remove 6 screws from brushroll cover (Fig. -
Page 15: Troubleshooting
TROUBLESHOOTING Make sure vacuum is turned off and power cord is unplugged. N O T I C E : Thermal cut-off This vacuum cleaner has a special thermostat that protects the vacuum in case of motor overheating. If the vacuum suddenly shuts off, proceed as follows: 1) Push the power switch to off and unplug the vacuum. -
Page 16: Warranty
DISPOSAL Appliances bearing the symbol shown here may not be disposed of in domestic rubbish. You are required to dispose of old electrical and electronic appliances like this separately. Please visit www.recycle-more.co.uk or www.recyclenow.co.uk for access to information about the recycling of electrical items. Please visit www.weeeireland.ie for access to information about the recycling of electrical items purchased in Ireland. - Page 17 SPARES Visit www.swan-brand.co.uk or call 0333 220 6050 Image Part name Part number Dusting brush tool SC15836N-01 Crevice tool SC15836N-02 Upholstery tool SC15836N-03 Flexible telescoping SC15836N-04 crevice tool 2-in-1 upholstery tool SC15836N-05 Turbo brush SC15836N-06 SC15836N-07 Brushroll SC15836N-08 Hose SC15836N-09 Belt SC15836N-10 Detachable handle...
- Page 18 NOTES SC15836_38_IM.indd 18 12/10/2020 14:43...
- Page 19 NOTES SC15836_38_IM.indd 19 12/10/2020 14:43...
- Page 20 www.eureka-swan.co.uk Copyright © Swan Products Ltd. PO Box 3117, Stoke-on-Trent ST4 9GD SC15836_38_IM.indd 20 12/10/2020 14:43...