Anti-Vibration Supports (Option); Non-Declared Uses - Swegon AQUA Link Installation, Use And Maintenance Manual

The slab must be:
– made in suitable foundation with a height of about 15-20 cm above the surrounding land,
– supplied with a cork gasket properly sealed along the perimeter,
– flat, horizontal and able to support 150% of the operating weight of the machine.
– at least 30 cm. longer and wider than the machine.
The units transmit a low level of vibrations to the ground: it is however recommended to interpose a band of rigid rubber
between the base frame and the support surface.
Anti-vibration mounts are recommended whenever thorough isolation is necessary (contact our company).

2.5 ANTI-VIBRATION SUPPORTS (OPTION)

As the unit does not have any moving components other than circulation pumps, it ensures a low level of vibrations
transmitted to the ground. Normally, the interposition of rubber strips between the ground and the base is sufficient to cancel
the effects of vibrations.
When it is necessary to further reduce vibration transmitted to the supporting structure, we recommend the use of rubber
shock absorbers available as optional accessories. The dimensional layout with the footprint on the ground, attached to the
machine, shows the position and load of each anti-vibration mount. The fixing operation of anti-vibration mounts must be
performed before placing the machine on the ground. Ensure that the lifted machine is properly secured to lifting cables.
In the event of installation on roofs or intermediate floors, the unit and the piping should be insulated from walls and ceilings.
The units should not however be placed near home offices, bedrooms or areas where low noise is required. Do not install
the unit in narrow or confined spaces in order to prevent excessive sound reverberation.

2.6 NON-DECLARED USES

The machine must not be used:
– in an explosive atmosphere;
– in inflammable atmospheres;
– in excessively dusty environments;
– by untrained personnel;
– in a manner contrary to law;
– with improper installation;
– with power supply defects;
– with total or partial non-compliance with instructions;
– with no maintenance and/or use of non-original spare parts;
– with changes or other actions not authorized by the Manufacturer;
– when the work area is not kept free of tools or objects;
– when the work area is not adequately clean;
– in the presence of abnormal vibration in the work area.
10