Troubleshooting - QEP 900 XT PRO Owner's Manual

WARNING
!
To avoid injury from accidental starting, always turn switch OFF and unplug the tool before moving, replacing
the blade or making adjustments.
PROBLEM
Motor does not start.
Saw is overheating.
Brush spark when switch
released.
The pump is not flowing
water.
cutting table is not
smooth.
Saw vibrates or shakes.
the laser guide or Led
light fails to turn on.
NOTe: If the problem continues, contact Customer Service. Telephone # 1-866-435-8665

TrOUBLeSHOOTING

PROBLEM CAUSE
1. Power cord is not plugged
into the socket.
2. Switch failure.
3. Brush worn.
4. fuse blown or circuit breaker
tripped on home panel.
1. the saw continues to operate
too long under pressure.
2. Blockage or dirt jams the
ventilation slots of the motor.
1. Brush worn.
2. other.
1. Water amount is not enough.
2. Water hose is jammed by dirt.
1. dirt is jammed too much on
the guide rails or cutting table
rollers.
1. Saw blade not round /
damaged / loose.
2. Blade not tightened on saw,
arbor bolt loose.
1. the batteries are dead.
2. the battery contacts need
adjustment.
SUGGeSTeD COrreCTIVe ACTION
1. Plug in properly.
2. replace switch.
3. replace brushes. See Maintenance section.
4. Verify there is electrical power at the outlet.
1. turn the saw off and let it rest until the motor is
cool to touch.
2. check and clean the ventilation slots of the motor,
removing blockage or dirt.
1. replace brushes. See Maintenance section.
2. contact Service center.
1. add water until the pump is submerged completely.
2. clean the water hose.
1. clean the dirt. Spread some machine oil on the
guide rails.
1. replace blade.
2. tighten arbor bolt.
1. replace with new aaa batteries.
2. reload the batteries and make certain that they
make solid contact to the battery spring.
24