Novus TagTemp-Stick Instruction Manual page 10

6.4 Collecting and Viewing Data
The data collection transfers the values recorded by the device to the
computer. The collect can occur at any time, during or after the
completion of the data acquisition process. If data collection occurs
during the acquisition process, this process is not interrupted, and
the operation is set according to the device configuration settings.
Collecting Data
When you select the "Collect" option in the application start screen,
another screen with the following options will be displayed:
Log File: This option allows you to upload stored log files for viewing,
customizing, preparing reports, or other functions.
Collect: This option allows transferring data from the connected
device. When you perform data collection, a progress bar is
displayed that indicates the progress of the transfer. The transfer
time will be proportional to the number of acquisitions recorded.
Viewing Collected Data
After the transfer of the records, the data collected are presented
graphically, as shown in the images below.
NOVUS AUTOMATION
6.4.1 Sharing and processing data
After completing the collection, a screen will be displayed with the
collected data and these are presented in two forms: in graph form
and table form. In the same screen, the general information of the
device and the data of the collected registers are shown.
Chart: You can select a region of the chart to be viewed in detail
(zoom). The zoom functions are accessed from the toolbar. You can
also expand a chart area with a click and drag the mouse by creating
a zoom region from the upper left corner of the desired chart area.
You can also display or not, the lines that delimit the alarm values, to
facilitate the visualization of the periods of these events.
Table of values: Shows the values acquired in table format,
indicating the moment of the measurement with its respective value.
TagTemp-S
10/11