Novus TagTemp-NFC Instruction Manual

TagTemp-NFC
TEMPERATURE LOGGER – INSTRUCTIONS MANUAL V 1.0x A
1 I
NTRODUCTION
The TagTemp-NFC is an electronic temperature logger. The sensor
measures this physical quantity and the values are stored in memory.
These data are collected by a smartphone equipped with an NFC
interface (not included).
The LogChart-NFC software enables to set up the equipment
operation mode. It is also used for viewing acquisitions. Other
parameters such as end of measurements, logging interval, etc., are
easily defined through the LogChart-NFC software.
The LogChart-NFC application is targeted to ANDROID™ platform
and must be downloaded from Google Play Store.
2 MECHANICAL INSTALATION
The TagTemp-NFC can be fixed in two ways: by using of screws or
double-sided tape.
For mounting with screws, you should detach the front film of the
equipment carefully, exposing two through holes where TagTemp-
NFC may be screwed, as shown in Fig.1. They should be used M3
flathead screws. When finished, you should stick extra film that
comes with the product to cover again the front of the device.
The other way is to use a double-sided adhesive tape on the back of
the equipment, avoiding placing it above the identification label.
In both cases, the temperature sensor should be placed near the
place where you want to measure the temperature.
Fig. 01 - Mounting holes on the TagTemp-NFC
NOVUS AUTOMATION
3 TECHNICAL DATA
Measure Range Temperature: -40.0 °C to 70.0 °C.
± 0.5 ºC @ 25 ºC.
± 1 °C max. over the full measuring
range.
Accuracy
Note: A measurement error can be
ruled out using the OFFSET parameter
in the LogChart-NFC software.
Measurement
Temperature: 0,1 °C / 0,1 ° F.
Resolutions
Memory capacity Up to 4020 logs.
5 minutes min.
Measurement Interval
2 hours max.
2 x 3.0 V lithium battery, built-in, non-
Supply
replaceable.
• Above 300 days – 5-minute logging
interval.
Estimated battery
autonomy
• Above 400 days – 30-minute
logging interval.
Operating temperature From -10 °C to 70 °C
Dimensions (L x W x H) Main body: 65 x 44 x 8 mm.
RF Interface ISO 15693 (NFC-V) compatible.
Logger-Smartphone Approx. 20 seconds (depends on the
data transfer time smartphone processing speed).
Android version: 4.0 or above.
LogChart-NFC
software
Languages: Portuguese and English.
USB to NFC converter interface
PC Interface (optional), compatible with LogChart-II
for Windows ®.
Material Polyamide
All electronics are protected by the
Protection
housing.
1/9