For Your Safety - Flex PE 14-2 150 Original Operating Instructions

PE 14-2 150, PE 14-1 180

For your safety

WARNING!
Before using the power tool, please read
and follow:
these operating instructions,
–
the "General safety instructions" on the
–
handling of power tools in the enclosed
booklet (leaflet
the currently valid site rules and the
–
regulations for the prevention of
accidents.
This power tool is state of the art and has
been constructed in accordance with the
acknow-ledged safety regulations.
Nevertheless, when in use, the power tool
may be a danger to life and limb of the user
or a third party, or the power tool or other
property may be damaged.
The polisher may be used only
as intended,
–
in perfect working order.
–
Faults which impair safety must be repaired
immediately.
Intended use
The polisher is designed
– for commercial use in industry and trade,
– for all types of polishing work with
polishing sponges, lambskins and
woolskins, felt plate, buffing disc,
– for use with polishing tools which are
permitted to run at a speed of at least
2600 r.p.m. (PE 14-2 150) respectively
1700 r.p.m. (PE 14-1 180).
Safety instructions for polishing
WARNING!
Read all safety warnings, instructions, illu-
strations and specifications provided with
this power tool. Failure to follow all instruc-
tions listed below may result in electric
shock, fire and/or serious injury. Save all
warnings and instructions for future
reference.
This power tool is intended to function as a

polisher. Read all safety warnings,
instructions, illustrations and speci-
fications provided with this power tool.
no.: 315.915),
-
Failure to follow all instructions listed
below may result in electric shock,
fire and/or serious injury.
Operations such as grinding, sanding,

wire brushing, or cutting-off are not
recommended to be performed with this
power tool.
Operations for which the power tool
was not designed may create a hazard
and cause personal injury.
Do not use accessories which are not

specifically designed and recommended
by the tool manufacturer.
Just because the accessory can
be attached to your power tool,
it does not assure safe operation.
The rated speed of the accessory must be

at least equal to the maximum speed
marked on the power tool.
Accessories running faster than their
rated speed can break and fly apart.
The outside diameter and the thickness of

your accessory must be within the
capacity rating of your power tool.
Incorrectly sized accessories cannot be
adequately guarded or controlled.
Threaded mounting of accessories must

match the grinder spindle thread. For
accessories mounted by flanges, the
arbour hole of the accessory must fit the
locating diameter of the flange.
Accessories that do not match the
mounting hardware of the power tool will
run out of balance, vibrate excessively
and may cause loss of control.
Do not use a damaged accessory. Before

each use inspect the accessory such as
abrasive wheels for chips and cracks,
backing pad for cracks, tear or excess
wear, wire brush for loose or cracked
wires. If power tool or accessory is
dropped, inspect for damage or install an
undamaged accessory. After inspecting
and installing an accessory, position
yourself and bystanders away from the
plane of the rotating accessory and run the
power tool at maximum no-load speed for
one minute.
Damaged accessories will normally break
apart during this test time.
13