Transport And Storage; Troubleshooting - MTD CSH40 Original Operating Instructions

EN

Transport and storage

Risk of injuries due to the cutting tool.
¾ Before transport or storage, switch off
the device and wait until the cutting tool
comes to a standstill.
¾ Activate the chain brake, remove the
power pack and fit the protective cover
before transport or storage.
Storage
Perform cleaning and servicing work before
Î
storage.
Store the tool in a dry location out of the reach of
Î
children.
When storing, ensure that no chain lubricating oil
Î
can run out.
Risk of injuries or material damage
¾ In case of doubt always consult a specialist workshop.
¾ Before any inspection or any work on the device, switch off the motor and remove the power
pack.
Problem Possible cause
Chain is too tight
Too much friction due to a lack of lubrica-
Chain becomes hot
tion
Chain is blunt
No oil in the tank
Chain is dry
Oil guiding groove is blocked
Chain is too loose
Uneven running,
Incorrect direction of rotation of the chain
heavy vibration
Chain or cutting bar damaged
The power pack is too hot.
The power pack is discharged.
The device switch-
The temperature of the device (electron-
es off.
ics) is too high.
Overcurrent release
The power pack is discharged.
Overcurrent release
The device will not
switch on.
Power pack temperature too high or too
low.
The power pack is defective.
Chain is blunt
Inadequate cut
Chain worn
36
WARNING!
Place the tool in an as horizontal as possible posi-
Î
tion with the oil tank closure facing upwards.
If storing for longer periods (4 weeks or more), re-
Î
move the chain lubricating oil, to prevent gumming
up of the lube oil pump.
Store the power pack and tool separately.
Î
Store the power pack in a cool and dry location.
Î
Recommended storage temperature approx.
18°C.
Keep the tool and especially its plastic compo-
Î
nents away from brake fluids, petrol, mineral oil
containing products, penetrating oils etc. They
contain chemical substances that can damage, at-
tack or destroy the plastic components of the tool.
Fertilizers and other garden chemicals contain
Î
substances that may have a highly corrosive
effect on the metal parts of the tool. Therefore do
not store your tool near to these substances.

Troubleshooting

WARNING!
Remedy
Adjust the chain tension
Fill with chain oil
Consult a specialist workshop.
Fill with chain oil
Clean the cutting bar
Adjust the chain tension
Fit the chain so it rotates in the correct direction
Consult a specialist workshop.
Allow the power pack to cool.
Charge the power pack.
Allow the device to cool and if necessary, clean
the ventilation slots
If this occurs again take your device to a special-
ist workshop.
Charge the power pack.
If this occurs again take your device to a special-
ist workshop.
Allow the power pack to cool down or warm up.
Replace the power pack.
Consult a specialist workshop.
Replace chain
Transport and storage