Installation Of Supplementary Arm Assembly - Launch TWC-581 Installation And Parts Manual

LAUNCH
Installation of Supplementary arm
assembly
Remove the left assist arm assembly from its skid,
remove the bolt and washer located on the top of
the pivot shaft (Fig.04), mount them as shown in
Fig.05.
Fig.04
Fig.05
Remove the cover on the left side of cabinet, with
a suitable lifting devise position the assist unit
(Fig.05) on the left rear corner of the cabinet
vertically, attach and fasten in place with bolts
and hardware provided.(Fig.06)
Fig.06
Remove the lock levers, brush a lubricant on the
parts threads, and then assemble them as in
Fig.07.
Finally feed the air line from the bottom of the
assist arm unit through the small hole on left
lower mounting plate into the cabinet. (Fig.08)
Fig.07
Fig.08
6
Tire Changer TWC-581