SKY-WATCHER Star Adventurer 2i Instruction Manual page 28

dithering range may result in longer total task time,
but too small dithering range may result in poor
dithering effect after photo stacking. Please adjust
dithering range according to your condition. Due to
the nature of dithering, Dithering only works when
Star Adventurer 2i control the camera shutter and
is not guided through Auto-Guiding Port.
WiFi Off on Run: When enabled, Star Adventurer 2i
will automatically turn off Wi-Fi at the start of a task to
save power. Wi-Fi can be restored at any time in APP
mode by pressing the Right/Left Button until Button
LEDs start slowly blinking.
Profiles Save / Edit: To save a profile tap Save. To edit
or delete a profile tap Edit. You can store your multiple
profiles of your favorite settings for recall at future
sessions.
Start the Task:
Once your tripod, Star Adventurer 2i and camera gear
are set up and all of your task parameters are set, just
press Run to initiate the task.
Cancel Current Task:
After your task started, you can cancel current task at
any time by tapping on STOP at the top-right corner
of the parameters screen. It brings up a confirmation
screen. You can cancel the Stop request and resume
the task or proceed to end the task at that point
Astrophotography Progress Screen:
Anytime you have a process running you can view its
progress by tapping on Status at the bottom of the
parameters screen. This brings up information about
number of photos taken, percentage of task complete,
etc.
28