SKY-WATCHER Star Adventurer 2i Instruction Manual page 15

3-Position Slide Switch: For selection of rotation
Buttons
direction in six preprogrammed function modes
( , , , , RT and LT). This function has no
effect in APP mode.
Buttons: The Right / Left buttons are used for
rotating in higher speed (about 12X celestial
tracking speed) in six preprogrammed function
modes ( , , , , RT and LT) . The slewing
function has no effect in APP mode. In APP Slide Switch
Shutter Control Port
mode, buttons are ONLY used to enable Wi-Fi if it
is disabled .
Snap : This is a 2.5mm 3-segment stereo jack for
connecting to a camera's shutter control port to
control camera shutter interval.
Auto-Guider: Star Adventurer 2i also contains
auto-guiding interface to accept single axis
(RA axis) auto-guiding signal to provide more
accurate celestial tracking for better quality of
astrophotography. The RJ-12 6-pin outlet is for
connecting an auto-guider. It is compatible with
any auto-guider with a ST-4 type interface. This
auto guide
function only works in Astrophotography Mode with
Dithering disabled and the tracking speed is not
USB
faster than 2 times of sidereal speed. For other
modes, the auto-guiding signal has no effect.
USB Port: Star Adventurer 2i contains a USB port
(Type Mini-B) to support external USB power and
to support control commands for firmware upgrade
or App control. For firmware upgrade, please refer
to "Appendix Ⅴ :Firmware Upgrade procedure "
for details For APP control please refer to " Using
Star Adventurer mini Console in APP mode" for
details.
15